How To Replace Coolant Elbow On 3800

How To Replace Coolant Elbow On 3800. The ones that are not broken, will now get broken, so just replaced both / all of them. Usually ready in 5+ days.

3800 Series III N/A coolant elbow replacement from www.ericthecarguy.com

V.fitting.the water pump and the block. I'd just take the other 3 bolts off the tensioner and replace that as you might as well replace both coolant elbows. The ones that are not broken, will now get broken, so just replaced both / all of them.

It Has Developed A Coolant Leak In A 90Degree Elbow Heater Hose Fitting (Hard Plastic) Between The.

The ones that are not broken, will now get broken, so just replaced both / all of them. Remove the two 13mm bolts from the tensioner. The coolant temp sensor on a 2003 chevy s10 v6 is located on the front of the intake manifold.

(Thanks Gm, Another 10 Cents Per Car For Original Aluminum Elbows And These Would Have Been Far Less Of.

Good advice though i'm not going to try and seal it, i'll do it properly. I figured i'd post this up given the amount of these coolant elbows i have had to replace over the years. Coolant is leaking from a small plastic elbow on the front of the engine right at manifold level and centerd.

Read >>  How To Replace Wiper Blades Bmw 3 Series

If The System Is Building Too Much Pressure And Boiling Over, Then You Need To Fix Why It Is Overheating.

Is it hard to replace a coolant elbow on a 3800 6 cylinder? Behind the tensioner there's a larger plastic elbow that it goes to and into the water pump. Flushed out the dexcool orange coolant and replaced with green prestone coolant.

I'd Just Take The Other 3 Bolts Off The Tensioner And Replace That As You Might As Well Replace Both Coolant Elbows.

It should be one of the water hoses that connects the tube on the front to the water pump, it is a preformed hose availiable from many parts stores and is not difficult to replace, if you drain a little coolant out before you take it off you will lose less coolant in replacement, be sure to refill coolant after your done. Both elbows are around $5 at the parts store under the help section. Ships from and sold by 911closeouts.

Both Ended Up Breaking Off Inside.

You must remove the entire belt tensioner bracket. It appears to runn from the intake to an unknown point behinde the belt tensioner. Usually ready in 5+ days.