How To Remove Inner Race From Hub

How To Remove Inner Race From Hub. The internal clearances are set so you don’t need to adjust the bearing. Need to replace the rear hub/bearing assy on my 01, did my research, picked up a new hub and got to work.

How to Remove a Wheel Bearing Inner Race in Under 5 from www.youtube.com

I've seen ppl use all sorts of tools to do this type of job from differential roll pins, screwdrivers, chisels, down to an acetelyne torch to heat the hub and watch the race fall out. Crank your mig welder up to medium heat, and run a quick bead part way around the inside of the outer race, carefully avoiding the casting. Press the hub stud out of the bearing using the appropriate tooling to prevent damage to the knuckle.

The Axle Caps Rest On The Inner Race While The Hub Shell Is On The Outer Race.

Use an air chisel to remove the inner wheel bearing race. The internal clearances are set so you don’t need to adjust the bearing. Press the hub stud out of the bearing using the appropriate tooling to prevent damage to the knuckle.

Also, A Link To A Video Of Removing And Reinstalling Bearings, Races, And Seals.

Races are difficult to remove but since you have one out already you can go into the opposite side from the race still in the hub and use a wooden rod to drive out the race. Turn off the torch and invert the inner race hub cone to remove the. For the inner race, you will need to use an inner bearing race removal tool like the bearing separator and puller set:

Read >>  Rank Them From Most Significant To Least Significant.

Fyi, Generally, The Harder It Is To Seperate, The More Likely The Hub Is.

Need to replace the rear hub/bearing assy on my 01, did my research, picked up a new hub and got to work. Place the (brass) punch in this groove against the backside of the race. I've seen ppl use all sorts of tools to do this type of job from differential roll pins, screwdrivers, chisels, down to an acetelyne torch to heat the hub and watch the race fall out.

Since The Race Just Sticks Out Just A Small Bit Past The Inner Hub Of The Rotor., You Can Find The Right Size Disk That Will Let You Knock That Race On Outta It.

Because those needle bearings are prone to disintegrating, allowing the axle to saw itself apart against the hub, whoever. Move the punch to the opposite side and repeat. Discussion starter · #1 · jun 3, 2013.

My Problem Was Figuring Out A Way To Get The Bearing Races Out Of The Aluminum Hub.

I do not recommend using any metal tool (unless it was designed for this application), only wood, because if the inner surface of the hub gets scratched it is pretty much done and would have to be replaced. Looking for suggestions on how to remove the outer race without changing the hub? The bearings are to be pressed in applying pressure to the outer race only.

Read >>  Going From Blue Hair To Brown