How To Install A Washdown Pump

How To Install A Washdown Pump. I have the idea of how to install the plumbing, but am curious of the electrical, i have 2 extra wires (orange and black stripe) when i look on the grady wiring diagram these were intended for livewell/washdown. I'll be installing a rule washdown pump this fall any tips on a easy install.

Johnson Washdown Pumps YouTube from www.youtube.com

Hose (garden hose will work ok above deck, but reinforced hose should be used for runs belowdecks.) 3. Place this out of the way but reasonably close to the water intake. The heart of any washdown system is, of course, the pump.

Installing A Washdown System Is Easily Within The Ability Of Most Any Diy’er.

Most pumps need to be installed in areas that stay dry. Most pumps need to be installed in areas that stay dry. Run the wire from the pump, to the helm, install a switch, and back.

Mount The Pump In A Convenient Location.

Boat already has a thru hull & strainer mounted for a wimpy pressure washdown pump so either its going to go or maybe i can tee off the strainer and use both. Choose an accessible location to install the pump, keeping the length of plumbing pipes and electrical wires to a minimum. Got tired of reaching overboard and getting water for the deck messes, so i purchased a jabsco 4gpm washdown pump kit.

Read >>  2015 Nissan Murano Headlight Bulb Size

And They Aren’t Difficult To Install.

Tilt panel out and remove. This video shows tj installing a wash down pump. And rom the pump to the placement of coil hose) 4 # 8 1/2 long pan head screws 4 #12 2 long pan head screws 3 # 10 taper head 3/4 long screws 14 ga wire in brown and black

Still, You Can Achieve An Even Quieter Installation, By Mounting The Pump On Rubber Hose.

Water supply options start by planning out your entire installation (hose runs, pump location, power supply, etc.) before drilling holes. As with everything, there's always an element of compromise between the optimum placement and where you can actually mount the pump. Mount the pump using stainless steel screws taking care not to over compress the vibration dampening rubber feet.

Just Wire It To One Of Your Fused Panel Switches And You're Ready To Go.

Carefully remove filter and clean with soft brush. Installation locate the pump in a dry location. I'll be installing a rule washdown pump this fall any tips on a easy install.