6.4 Powerstroke Oil Temp Sensor. My edge evo (gauges only) gave me an engine oil temp alarm at 230 degrees, shortly after this i hear the engine fan kick on hard, the coolant temp was about 220f and the oil temp was at about 230 the entire way up this hill. Ford has been making cars since 1919.
This product carries a six month warranty. Ford has been making cars since 1919. This oil temperature sensor is manufactured to ford’s strict calibration standards to meet or exceed the specifications of the original sensor in your truck.
You Will Need A Deep Socket And You Would Be Best To Drain The Coolant Below The Sensor.
We already talked about fuel dilution from the dpf regen cycles, but there is also another good reason to keep a close eye on your oil level. This results in an oil leak that may appear as a rear main seal leak. Ford vehicles equiped with the 6.4 powerstroke diesel are not rated for fuel economy by the epa.
The Sensor Is On The Front Cover To The Left Of The Power Steering Pump, When Looking At The Engine From The Front Of The Truck.
Alliant ap63437 engine oil/coolant (eot/ect) temperature sensor. All ford and motorcraft parts are backed by the best warranty in the. This sensor detects oil engine temperature and sends that message to the ecm.
This Product Carries A Six Month Warranty.
I believe the oil temp and water temp sensors are the same, maybe check that as a reference. The alliant ap63497 transmission fluid temperature sensor is a direct replacement for the oe trans. Ford has been making cars since 1919.
I've Noticed That When On The Highway, My Coolant Temp Will Run Around 200 While My Oil Temp Runs Around 250.
We offer the best online prices with fast shipping on any order placed with us. Also i'm not very good with voltmeters but. Cold start ect/eot read the same as outside.tranny temp usually +3 over outside.
It Was Probably 90 Degrees Today.
If economy is in question, a boost test should be performed. Ford parts 6.7l oil temp sensor. Oil is flowing thru the cooler, i was just giving the reading to show it's within the oem range for psi at idle at the port.